How To Install Skirting Board

Installing skirting boards can protect the walls from damage and greatly enhance the appearance of the room. But do you know how to install these skirting boards? There are many ways to install skirting boards, some are traditional ways while some are modern.

Here’s A Detailed Guide On How To Install Skirting Boards:

Preparation

Collect all required equipment and supplies before you start.

• Skirting boards


• Pint scrapper


• Square


• Combination saw


• Screws and nails


• Kwick Grip clamps


• Gloves and safety goggles


• Cordless glue gun


• Stud finder


• A measuring tape


• Rubber mallet


• Adhesive


• Copping saw


• Hammer or drill


• Pencil


• Spirit level

Step-by-step Procedure To Install Skirting Boards

It consists of the following steps:

• According to the size of your room, adjust your skirting. Aim to clear out any joints in the middle of the wall. They should be placed near a corner ideally as opposed to this, where any furniture is likely to cover them.



• Complete the markings with your pencil for your skirtings.



• Cut the skirtings using a mitre box, preferably from the front to prevent any damage. To prevent wasting any skirting, it’s important to make sure you cut You can cut to an interior or exterior angle, depending on the kind of corner they are heading onto. Here, exercise caution as the incorrect angle can waste your skirting and is unlikely reusable.



• After cutting use sandpaper to smooth the jagged edge. To provide a satisfactory fit, slightly resaw or chisel the material if required.



• Drill a little hole in the skirting to accommodate the screw size if attaching to a stone wall and use the appropriate kind of rawlplug. Align a hole of the same size in the wall and drill a hole for the rawlplug after the hole has been created. Screw the skirting into place after inserting the plug into the wall.


• When fixing a timber stud wall, make sure to attach it at the location where the stud is behind the plasterboard. The skirting can be fastened to the wall with a screwdriver and screw or a nail gun.



• To attach to the wall, use an adhesive that says “no more nails” as an alternative.



• Fill in any fastening holes with an appropriate filler substance and sand before painting.



• Especially if the wall isn’t perfectly flat, fill the space at the top of the skirting with caulk and an applicator gun.

Safety Tips And Tricks For Installing Skirting Board

The following are some installation safety guidelines for skirting boards:

• To shield your eyes from debris and your hands from sharp objects and tools, you can put on protective gear.


• When you are working with paints or adhesives you should work in a well-ventilated location.


• For safer and more effective installation make sure you are using the right kind of tools. Miter saw Level, Nails, Hammer, Measuring tape, and Pencil necessary for the task.


• Before nailing or drilling keep an eye out for electrical wires and pipes to prevent damaging them behind walls.


• Proper fasteners like nails or adhesives should be properly used and fixed to install the boards properly to keep the boards from falling loose and creating a trip hazard.


• At regular breaks take breaks to avoid getting tired and lower your chance of getting hurt.


• To guarantee a safe and efficient use you must carefully follow the manufacturer’s instructions.

Maintenance Of Skirting Boards

To avoid accumulation, installed skirting boards should be routinely dusted and wipe-finished with a moist towel. Replace or repair any loose or broken parts after their examination. Check for wear and deterioration regularly and steer clear of harsh chemicals that can harm the finish.